replacement pivot point "bearing plates" on the am
Posted: Fri 01 Sep 17, 16:18
Hi there.
I have too replace the round, white plastic which are sitting on the amas pivot points.
Does anyone has done this?
What kind of material is it, or is there a better material to take instead of the original?
Mine are worn out by the sun.
Did someone got the drawings/measuremets for the 920?
Would be easier to get them water cut with cnc data.
Best regards Björn
I have too replace the round, white plastic which are sitting on the amas pivot points.
Does anyone has done this?
What kind of material is it, or is there a better material to take instead of the original?
Mine are worn out by the sun.
Did someone got the drawings/measuremets for the 920?
Would be easier to get them water cut with cnc data.
Best regards Björn