DRAGONFLY Trimarans User Forum

Anyone have a specification to upgrade the hinge bolts on my DF800sw?

noticed the close proximity of the nuts so concerned on making the new holes too big!

Hi Steviec14

I have just had the hinge bolts replaces with bigger ones. The replacement was done by the service department at Quorning Boats in Skærbæk. I can see that they have replaced some of the nuts close to the bolt in order to make room for it. I can send you some pictures of the new installation if you like?

Best regards
Brian

Hi Brian

If you could that would be so helpful or email to
Sculpitt at me dot com

Kr

Steve

Hi Steviec14

Here is some pictures: https://www.dropbox.com/sh/v12pen30hn4i ... osNGa?dl=0
Let me know if you need pictures on specific details.

Br,
Brian

Thank you Brian

Really helpful, I am guessing the bolts are 16mm?

Can I ask a rude question - how much did the parts cost?

Steve

Hi Steve

Yes, it is 16 mm bolts.

I don't know the price as they came with the boat when I bought it this spring. The previous owner only purchased them but net got to install them. I think he got them through after sales at Quorning Boats.

Best regards
Brian

I have done this project for both DF1000R and DF800SW.

There was a LOT of problems with DF800 technical structure. Very bad workmanship by the manufacturer. I have quite good 3D CAD files and other documentation about the project. It took about 200h to replace all SW system mechanics, build a new mainsail traveler track and fix all the structural problems.

Result is good, much better than the original structure.

See attached files.

Please click on any of the photos to see them enlarged!




OikTakaSaranaKoneistus020518.pdf
4LevankiKokPano200318.pdf
1LevankiKokPano200318.pdf
11LevankiKokPano200318.pdf
10LevankiKokPano200318.pdf

Hi Mirka

Like to see some images of the end result.

Mika Harju wrote:I have done this project for both DF1000R and DF800SW.

There was a LOT of problems with DF800 technical structure. Very bad workmanship by the manufacturer. I have quite good 3D CAD files and other documentation about the project. It took about 200h to replace all SW system mechanics, build a new mainsail traveler track and fix all the structural problems.

Result is good, much better than the original structure.

See attached files.

Please click on any of the photos to see them enlarged!




OikTakaSaranaKoneistus020518.pdf
4LevankiKokPano200318.pdf
1LevankiKokPano200318.pdf
11LevankiKokPano200318.pdf
10LevankiKokPano200318.pdf

Hi Mika
I would also like to see some pictures of the result

Best regards Thomas